The STDi-24 point of use water detector is comprised of two components: the detector module and the point detector, connected together via a 1m jumper cable.
Both the detector module and point detector are manufactured from STAREX General ABS (SD-0150) plastic. The detector module houses the electronic circuitry and the point detector houses the gold plated detection pins. The jumper cable is connected to the top of the point detector via a 3-pin plug and socket.
Conductive fluid touching the two detection pins simultaneously will cause the detector to enter an alarm condition. Alarm status and monitoring is via a network, using a CAN bus system.
A stabilising bar is required as a means of fixing the point of use detector to the floor surface.
BS EN ISO 9001:1994
EMC Directive 89/336/EEC
Module: 45 (h) x 70 (w) x 135mm (l)
Detector: 65 (h) x 55mm (w)