The STDi-24 point of use conductive water detector is designed for use in plant rooms and other solid floor areas. It has two components - the detector module and the point detector - connected by a 1m jumper cable.

Both the detector module and point detector are manufactured from STAREX General ABS (SD-0150) plastic.

The detector module houses the electronic circuitry. The point detector houses the gold plated detection pins. The jumper cable is connected to the top of the point detector via a 3-pin plug and socket.

Conductive fluid touching the two detection pins simultaneously will cause the detector to enter an alarm condition. Alarm status and monitoring is via a network, using a CAN bus system.

A stabilising bar is required as a means of fixing the point of use detector to the floor surface.

  • For use within plant rooms and other solid floor areas

  • For detection of conductive water

  • Manufactured from rust-proof and hard-wearing ABS plastic

  • Gold-plated detecting pins

  • Two component design – keeping head and electronic module separate

  • LED and internal alarm sounder in module to give local alarm indication

  • Multiple types of protection covers are available to prevent mechanical damage

  • For connection to i-Zone or i-Zone Touch control panels

Data

  • Normal operating voltage: 24 volts DC

  • Quiescent current: <10mA per detector

  • Alarm current: <100mA per detector

  • Detector oscillator frequency: 6kHz

  • Recommended interconnecting cable: 120Ohm 4 core 0.5mm2; screened twisted pair

  • Line-out voltage drop: 1.5mV/m

Approvals

BS EN ISO 9001:1994
EMC Directive 89/336/EEC

Dimensions

Module: 45 (h) x 70 (w) x 135mm (l)
Detector: 65 (h) x 55mm (w)